From: hristo (hristo_at_mail.galaxite.net)
Date: 2002-04-07 08:56:51 UTC
Hi list,
My Question is how to make bridge between to wired networks.
I want the link to be dedicated one. Following setup:
LAN<--� eth0/wlan0<---�wlan0/eth0<----�LAN1
I mean that wireless interfaces should talk only to each
other, no AP functionality. No other wirless clients shod be
able to talk to wlan interfaces. If I put to wlan cards in
Add-Hoc will bridge code (STP) take care of the rest? In
general I want to optimize performance. How to do such
setup?
Any Ideas are welcome
Regards
Hristo Nazarow
PS: By the way there is new firmware 1.3.5:
http://www.actiontec.com/support/wireless/80211b_pccard/inde
x.html
I think it is suitable foe our cards, but I have not tried
to flash my cards yet. You can take a look at it.