From: mikeraz_at_PATCH.COM
Date: 2002-06-10 12:54:27 UTC
Looking for help here. My freshly installed Linksys WMP11 card being driven with the HostAP driver does not come up in 802.11b mode and does not respond to a iwconfig rate set:
[root_at_dawg modules]# iwconfig wlan0
wlan0 IEEE 802.11-DS ESSID:"www.personaltelco.net" Nickname:"patch" Mode:Master Frequency:2.422GHz Access Point: 00:06:25:A7:22:8E Bit Rate=2Mb/s Tx-Power:-7 dBm Sensitivity=1/3 Retry min limit:8 RTS thr:off Fragment thr:off Encryption key:off Power Management:off Link Quality:0 Signal level:0 Noise level:0 Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0
[root_at_dawg modules]# iwconfig wlan0 rate 11M
[root_at_dawg modules]# iwconfig wlan0
wlan0 IEEE 802.11-DS ESSID:"www.personaltelco.net" Nickname:"patch" Mode:Master Frequency:2.422GHz Access Point: 00:06:25:A7:22:8E Bit Rate=2Mb/s Tx-Power:-7 dBm Sensitivity=1/3 Retry min limit:8 RTS thr:off Fragment thr:off Encryption key:off Power Management:off Link Quality:0 Signal level:0 Noise level:0 Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0
I'm not finding mention of this in the source configuration - other than a case statement which sets the string.
So what am I missing in getting this driver/card combination set up to do 11Mb/s?
Other than this issue the compilation and installation was nearly effortless.
-- Michael Rasmussen aka mikeraz Be appropriate && Follow your curiosity "They that give up essential liberty to obtain temporary safety, deserve neither liberty nor safety." -- Benjamin Franklin and the fortune cookie says: Don't kiss an elephant on the lips today. In good speaking, should not the mind of the speaker know the truth of the matter about which he is to speak? -- Plato