From: Terry Hardie (terryh_at_orcas.net)
Date: 2002-06-24 04:18:09 UTC
On Mon, 24 Jun 2002, Manjunathan PY wrote:
> Hi,
> I have setup a bridge between wirless LAN and Wired LAN as shown below
>
>
> (Bridge Br0 on Linux box)
> ____________________
> | |
> station....air if....wlan0---HostAP---eth0---wiredLAN---Proxy---internet
> |____________________|
>
> I am not able to browse the internet from the station. I used ethereal on
> the HostAP linux box (which is also acting as bridge )
> to monitor the http request, I noticed that http request reaches the
> internet Proxy server. But the station is not able to receive any packets
> from the internet proxy.
>
> Note: I used bride-utils by Lennert Buytenhenk to setup the bridge in the
> linux box , I am using Prism2 HostAP driver.
> Route table is as follows
> Destination Gateway Genmask Flags Metric Ref Use
> Iface
> 217.1.128.0 * 255.255.255.0 U 0 0 0 br0
> loopback * 255.0.0.0 U 0 0 0 lo
> default gateway.irc.com 0.0.0.0 UG 0 0 0 br0
>
> Can any one please explain why I am NOT able to browse the internet? The
> browser used to display "Connected to www.google.com ..." and thats it. No
> further response at all.
>
> After a lot of struggle, I figured out that if I set the MTU size (Maximum
> Transmission Unit) to anything less than 1400 bytes in the Station, I was
> able to browse the internet.
I am running this exact configuration, and it works fine. I have heard of this problem on other access points (Specifically the linksys AP 2.5), and there is somehow a relationship with encryption and encryption size. It should work if you turn off encryption, but I don't know what the root cause is.
As I said, I'm running with 128 bit encryption and bridging, and everything works fine.
--- Terry Hardie terry_at_net.com SHOUTip Engineering Product Manager ICQ#: 977679 net.com, 6530 Paseo Padre Parkway Mailstop #2207, Fremont, CA 94555, USA V: +1-510-574-2366