Fail to set CNFMULTICASTPMBUFFERING to zero


From: Sunny Lai (ktlai_at_ie.cuhk.edu.hk)
Date: 2002-08-28 10:12:22 UTC



Hello,

I am doing some mulitcast buffering research, so I like to disable the cards multicast buffer by the following code in the "prism2_setup_rids" routinue.

	ret = prism2_set_word(dev, HFA384X_RID_CNFMULTICASTPMBUFFERING,
			      0);
	if (ret) {
		printk("%s: CNFMULTICASTPMBUFFERING setting to %d failed\n",
		       dev->name, 0);
	}

But with failure as show below. Does anyone have any advice?? Thanks.......

hostap_plx: hostap_plx.c 0.0.0 2002-05-19 (SSH Communications Security Corp, Jou
ni Malinen)
hostap_plx: (c) SSH Communications Security Corp <jkm_at_ssh.com>

PCI: Found IRQ 10 for device 02:08.0
PCI: Sharing IRQ 10 with 00:1f.3
PCI: Sharing IRQ 10 with 00:1f.5

PLX9052 PCI/PCMCIA adapter: mem=0xff6ffc00, plx_io=0xdc80, irq=10, pccard_io=0xd
c00
hostap_plx: CIS: 01 03 00 00 ff 17 ...
hostap_plx: manfid=0x0274, 0x1613
hostap_plx: cor_index=0x1 cor_offset=0x3e0
Prism2/2.5 PC Card detected in PLX adapter PLX_INTCSR=0x1063
PLX_CNTRL=0x187866d2 (Serial EEPROM present=1)
hostap_plx: Registered netdevice wlan0
prism2_hw_init()
prism2_hw_config: initialized in 16757 iterations
wlan0: NIC: id=0x801b v1.0.0
wlan0: PRI: id=0x15 v1.0.7
wlan0: STA: id=0x1f v1.3.5
wlan0: CMD=0x0121 => res=0x7f, resp0=0x0004
wlan0: hfa384x_set_rid: CMDCODE_ACCESS_WRITE failed (res=127) wlan0: CNFMULTICASTPMBUFFERING setting to 0 failed device eth1 entered promiscuous mode
device wlan0 entered promiscuous mode
eth1: Setting promiscuous mode.

Best Regards,

Sunny Lai



This archive was generated by hypermail 2.1.4.