From: Jason Boxman (jasonb_at_edseek.com)
Date: 2002-08-29 16:17:45 UTC
On Thursday 29 August 2002 08:56 am, Ted Phelps wrote:
> "Ryan Abbenhuys" may have said:
> > Could you perhaps step me through the installation process. For some
> > reason time and time again I keep getting Unresolved Symbols in the 3
> > modules mentioned below. Even when I start on a completely new Redhat
> > system with a fresh installation.
>
> I had a similar problem, which might be related to what you're seeing.
> When I insert the card, cardmgr tries to load the hostap_cs module
> using modprobe. If that fails it falls back to using insmod, which
> won't work because it won't get the module dependencies, leaving you
> with a huge stack of unresolved symbols.
<snip>
> Last time I checked, the parameters were as follows:
>
> hostap_cs.o: irq_mask, irq_list, ignore_cis_vcc, mtu, channel, essid,
> iw_mode, beacon_int, dtim_period, delay_enabled,
> disable_on_close, bus_master_threshold_rx and
> bus_master_threshold_tx
>
> hostap.o: other_ap_policy, ap_max_inactivity, ap_bridge_packets,
> autom_ap_wds
That'd be useful in documentation, since I didn't even know about those. :)
>
> Hope this helps...
>
> Cheers,
> -Ted
-- Jason Boxman Administrator TrekWeb.COM http://trekweb.com/~jasonb/articles/ - Linux Pages