From: Nigel Jones (nigel_at_planetf1.worldonline.co.uk)
Date: 2002-02-21 21:01:45 UTC
I'm having difficulty using the 2002-02-13 driver in Ad-hoc mode.
pcmcia-cs is 3.1.31, kernel 2.4.17 newnat2
Without WEP the driver works fine, if I issue
ifconfig wlan0 key 1111-1111-11 restricted
the output from ifconfig wlan0 is unchanged
similarly
iwconfig wlan0 sens 2
causes no change in the sensitivity
Reviewing the kernel messages I see:
wlan0: INFO - fid=0x00c3 - len=2 type=0xf200
LinkStatus=2 (Disconnected)
wlan0: hfa384x_setup_bap - timeout3
wlan0: prism2_tx - to BAP0 failed
prism2: eth0: resetting card
prism2_cor_sreset: original COR 41
wlan0: CMD=0x0002 => res=0x7f, resp0=0x0001
prism2: Shutdown failed
prism2_hw_config()
prism2_hw_config: initialized in 9260 iterations
wlan0: TXEXC - fid=0x010f - status=0x0004 ([Discon]) tx_control=000e
retry_count=0 tx_rate=0 fc=0x0008 (Data::0)
addr1=00:05:5d:f1:e0:87 addr2=00:05:5d:f1:d7:43 addr3=02:23:46:f4:e0:87
wlan0: hfa384x_setup_bap - timeout3
wlan0: prism2_tx - to BAP0 failed
prism2: eth0: resetting card
prism2_cor_sreset: original COR 41
wlan0: CMD=0x0002 => res=0x7f, resp0=0x0001
prism2: Shutdown failed
prism2_hw_config()
prism2_hw_config: initialized in 9252 iterations
wlan0: TXEXC - fid=0x010f - status=0x0004 ([Discon]) tx_control=000e
retry_count=0 tx_rate=0 fc=0x0008 (Data::0)
addr1=00:05:5d:f1:e0:87 addr2=00:05:5d:f1:d7:43 addr3=02:23:46:f4:e0:87
wlan0: INFO - fid=0x02b0 - len=2 type=0xf200
I need to look into what's going wrong on the reset... but if anyone's got any ideas.... BTW the firmware is 8c3 - it's a prism2 dlink-dwl650
Thanks
-- Nigel Jones nigel_at_planetf1.worldonline.co.uk